NextBlend Spray Spot Blender

NextBlend is the spot blender formulated by VerniciSpray: a practical and easy solution in case of repair paint jobs and spot repairs to ensure seamless edge transitions in the blending area.
The spray blend thinner helps you getting a homogenous paint transitions in the blending area without those awful gaps between old and new paint that always make the repairs too visible. The shading areas often appear rough, but spraying our blender in very small coats in the transition area between old paint and new paint, you will make the surface homogeneous and perfectly gloss.
It is essential to use the blending thinner in the right way and with caution: it is a solvent actually, so, if used in excessive quantities, can ruin the work instead of improving it.
Application advices: the spot blender drips easily and evaporates quickly, we therefore recommend applying very thin coats in small sprays with an interval of a few minutes and keeping more distance from the surface than when you apply paint (about 20-25 cm, but it is better to evaluate by yourself, if it runs away it is better to increase the distance or spray it in a smaller quantity). The spot blender is applicable on both our solid colours (direct gloss) and metallic car paints (double coat). For direct gloss colours: spray the blending thinner after the last coat of paint, when it is almost dry but not completely, it must have lost the wet effect typical of fresh paint and be a little dry to the touch. For double-coat metallic colours: spray the blending thinner once both paint and clear coat have been applied, the clear coat has to be not completely dry. In all cases the spray blender must be applied in the run-out zones of new paint (or clear coat) during the repair of small damages gap to get the blending between the old and new paint: that blending area must be already created during painting, even if you know that you are going to use the NextBlend later.

The blender spraycan is equipped with a low-pressure and low-flow nozzle to avoid possible dripping and help you apply less product all at once.